PULNiX AMERICA, INC.
PULNiX America, Inc.
1330 Orleans Drive
Sunnyvale, CA 94089
Tel: 408-747-0300
Tel: 800-445-5444
Fax: 408-747-0660
Innovation at work!
AccuPiXEL Series TM-4000CL
71-0051 Rev. C
Imager
Active Area
Active Pixels
Cell size
Display Mode
(Active Pixels)
Sync
Data clock output
Resolution
S/N ratio
Min. illumination
Video output
1.2" progressive scan interline transfer CCD
15.15mm x 15.15mm
2048 (H) x 2048 (V)
7.4 µm x 7.4 µm
2048 (H) x 2048 (V) @ 7.5/15 Hz
2048 (H) x 1000 (V) @ 15/30Hz (partial scan)
Internal/external auto switch
HD/VD, 4.0 Vp-p impedance 4.7KΩ
VD=7.5 / 15 Hz ±2%, non-interlace,
HD=15.39 / 30.78 kHz±2%
20.00 / 40.00 MHz
Digital: 2048 (H) x 2048 (V),
Analog: over 800 TV lines (H) x 1600 TV lines (V)
50dB min. (AGC off)
1.0 lux, f=1.4 (no shutter) @15 fps
Sensitivity: 13µV/e-
Analog: 714mV, 75Ω (900 mV white clip),ChA only
Digital output: 8-bit x 2 Camera Link
10-bit x 2 Camera Link optional
TM-4000CL Progressive Scan High-Resolution Shutter Camera
AGC
Gamma
Lens mount
Power req.
Operating temp.
Vibration
Shock
Size (W x H x L)
Weight
OFF
Programmable LUT(1.0 std.)
C-mount (use>1" format lenses)
12V DC±10%, 600 mA
(current measured at 25°)
-10°C to 45°C*
7Grms (10 Hz to 2000 Hz) Random
70G
50mm x 50mm x 70mm (1.97" x 1.97" x 2.75")
150 grams, oz (without tripod)
* Image quality will degrade with increasing temperature.
Graphical User Interface
A user-friendly graphical user interface (GUI) is provided in
the CS-232E kit. This interface allows users to control the fol-
lowing functions of the TM-4000CL camera:
•
Shutter control for manual async. and
pulse width control
•
Gain control
•
A/D reference voltages control for Vtop and Vbottom
•
Save settings
•
Load settings
•
Report settings
•
LUT setting and graphic display
•
Scanning mode selection and Option selections
Camera parameters can be
uploaded from the PC to the camera.
Once these parameters are stored in
EEPROMs, an instantaneous change
from one setting to another can be
done with a delay of few frames in
between.
Serial Communication
Kit
The serial communication kit CS-
232E consists of serial cable RS-
232B-12, a software disk, and a
quick-start guide. The RS-232B-12
cable has a 12-pin connector on the
camera end, and a 9-pin D-sub
connector (RS-232) and a 12-pin
connector (power and sync signals)
on the other end. For Camera Link
.dll software, please contact PULNiX.
Comentarios a estos manuales