Pulnix TM-200 Manual de instrucciones descargar pdf (Pagina 23)

OPERATION

Page 18 TM-1300 Progressive Scanning High Resolution Camera

3.1.5 (g) 8. Freeze (ENINT) Enable

The internal frame buffer can freeze the image by selecting this function. When the up/down switch is

pushed up, it is a real time image. When it is down, it freezes the ﬁnal image. This freeze mode is also

used for integration control. At freeze mode, the TM-1300 can be used to integrate (log exposure) by

controlling INTEG control input on 12-pin connector (pin #11). It keeps integrating as long as the pin

#11 is low and grabs an image when the integration is over.

3.1.5 (h) 9. Factory Default Recall

When mode 9 is selected at power up, camera starts with the factory set parameter. When camera is

already powered, select the switch #9 and press up/down switch up to recall factory default. (User

cannot change this parameter)

3.1.5 (i) A. User Default Page

This page is a default page for camera start up. When camera is powered up, it starts operating with the

parameters stored in page #A except switch positions of #9 (factory set), #B through #D (user set

speciﬁc pages).The last changes during optimization should be stored in page #A so that the default will

be recalled upon next power up.

3.1.5 (j) B. through D. User Pages

User can store speciﬁc parameters in pages from B through F.

3.1.5 (k) E. Direct Shutter

This mode accepts shutter control by every 1H (80µsec) increment (up) or decrement (down) for 1/12

sec to 1/39,000 sec. If RS-232C is connected, the exact shutter control number (1H to 1000H) is

applied.

3.1.5 (l) F. Fast Dump

One of the unique features of the TM-1300 is the capability of fast dump charges kept inside of the

CCD’s vertical shift registers prior to image integration in async reset mode. This feature reduces

vertical smear lines from a point light source during fast shutter conditions. The lower side smear,

however, cannot be reduced due to the CCD structure.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 43 44

Sin comentarios

Pulnix TM-200 Manual de instrucciones Pagina 23