Pulnix TMC-4200CL Manual de instrucciones Pagina 33

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 70
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 32
Page 23
Installation
TM/TMC-4200CL Series Progressive Scan Cameras
Mount the camera on a large heat sink (camera bracket) made out of heat-conductive material like
aluminum.
Make sure the flow of heat from the camera case to the bracket is not blocked by a non-conductive
material like plastic.
Make sure the camera has enough open space around it to facilitate the free flow of air.
Please contact JAI at (800) 445-5444 or send an E-mail to im[email protected] if you have any
questions.
5.2.2 Connector Pin Configurations
5.2.2 (a) 12-Pin Connector
The TM-4200CL has a 12-pin Hirose connector for power input and signal integration. Pin #1 is
Ground and pin #2 is +12V DC. The pin-out table is shown below. Serial communication camera
control is accomplished by means of the Camera Link connector on the rear panel of the camera.
TABLE 1. 12-Pin Connector
FIGURE 36. Hirose Connector
Pin Description Pin Description
1 GND 7 VD in
2 +12V DC 8 Strobe
3 GND (analog) 9 HD in
4 Video out 10 NC
5 GND (digital) 11 Reserved
6 VINIT in 12 NC
1
2
3
4
5
6
9
8
7
11
12
10
Vista de pagina 32
1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 69 70

Comentarios a estos manuales

Sin comentarios