Pulnix TMC-6700 Series Manual de instrucciones descargar pdf (Pagina 18)

Page 10

Installation

TMC-6700/1000 Series Progressive Scan CCD Digital Color Camera

2.2.2 (b) PULNiX Power Cables

If you are using PULNiX power cables, such as the 12P-02S, please refer to the12-pin connector pin-out

diagram in Section 2.2.1 on page 7. The cable pin-out diagram is shown below in Figure 3. The color-

coded leads use Gray for Ground and Yellow for +12V DC.

WARNING: When applying power to the camera, using one of the 12-P

series cables, make sure that none of the exposed leads on the

multiple conductor cables are touching, as this may cause dam-

age to the camera.

FIGURE 3. 12P-02S Interface Cable (optional)

Note: Make sure that the unused leads are not touching and that there is no possibility that the

leads could short due to exposed wires.

2.2.2 (c) Building Your Own Power Cable

Please refer to the 12-pin connector (PC-12P) pin-out in Section 2.2.1 on page 7. Connect the Ground

lead to Pin #1, and the +12V DC (0.5A) lead to Pin #2 of the 12-pin connector.

2.2.2 (d) Attaching the Power Cable to the Connector

The 12-pin connector is keyed and will fit in only one orientation. Follow these directions to properly

attach the power cable to the camera connector:

1. Rotate the connector while applying slight pressure until the keyway lines up.

2. Press the connector into place until it is firmly seated.

3. Plug the power cord into the 110V AC socket. This will power up the camera.

12P-02S Interface Cable

Pin# Lead Color Function Pin# Lead Color Function

1 Gray GND 7 Black coax signal VD IN

2 Yellow +12V DC 8 White shield GND

3 Red shield GND 9 White coax signal HD IN

4 Red coax signal N/C 10 Brown N/C

5 Orange shield GND 11 Blue INTEG CONT

6 Orange coax signal VINIT 12 Black shield GND

HD In (White Coax)

Video Out (Red Coax)

VD In (Black Coax)

Power (Yellow)

GND (Gray)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 47 48

Sin comentarios

Pulnix TMC-6700 Series Manual de instrucciones Pagina 18