Pulnix TM-1300 Manual de instrucciones descargar pdf (Pagina 16)

Page 8

Installation

TM-4000CL Series Progressive Scan Shutter Cameras

FIGURE 3. 12P-02S Interface Cable (optional)

Note: Make sure that the unused leads are not touching and that there is no possibility that

exposed wires could cause the leads to short.

2.2.4 (c) Building Your Own Power Cable

Refer to the 12-pin connector pin-out in Figure 3 on page 8. Connect the Ground lead to pin #1, and the

+12V DC lead to pin #2 of the 12-pin connector. Power must be DC-regulated, and of sufficient current

to properly power the camera.

2.2.4 (d) Attaching the Power Cable to the Connector

The 12-pin connector is keyed and will only fit in one orientation. Follow these directions to properly

attach the power cable to the camera connector:

1. Rotate the connector while applying slight pressure until the keyways line up.

2. Press the connector into place until firmly seated.

3. Plug the power cord into the 100V AC socket. This will power the camera up.

2.2.5 Attaching the Analog Video Output

When connecting the TM-4000CL to an analog frame grabber or a monitor, use the BNC connector on

the rear panel of the camera. The input of the monitor should be balanced for 75 ohms termination.

Standard RG-59 type coaxial cable should carry a full video signal for up to 500 feet. The TM-4000CL

has a two-row binning mode that can be used to display real-time images on PULNiX’s PVM-942 or

PVM-1242 monitors. These monitors are specially modified to accept a 30Hz progressive scan image.

12P-02S Interface Cable

Pin# Lead Color Function Pin# Lead Color Function

1 Gray GND 7 Black coax

VD Input

2 Yellow +12V DC 8 White coax shield Strobe out

3 Red coax shield (analog) 9 White coax

HD Input

4 Red coax Video Out 10 Brown

RXD (RS-232)

5 Orange coax shield (digital) 11 Blue

Integration

6 Orange coax

VINIT IN

*. Optional

12 Black coax shield

TXD (RS-232)

HD In (White Coax)

Video Out (Red Coax)

VD In (Black Coax)

Power (Yellow)

+12 V

Monitor

Analog

Frame Grabber

GND (Gray)

}

Male

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Comentarios a estos manuales

Sin comentarios

Pulnix TM-1300 Manual de instrucciones Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para Cámaras Bridge Pulnix TM-1300