Pulnix TS-9720EN Series Manual de instrucciones Pagina 11

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 63
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 10
TS-9720EN Series Progressive Scan Shutter Cameras
Page 3
Getting Started
2 Getting Started
2.1 Required Equipment
FIGURE 1. Typical Equipment Setup
PD-12 power supply
Cat5e/6 Ethernet cable
10/100/1 G Ethernet switch
Debug-232 serial/power cable (JAI PULNiX part number 31013219)
2.2 Network Settings
2.2.1 Default Network Settings for the TS-9720EN Camera
The factory default network setting for the TS-9720EN is the following:
IP address : 10.0.0.65
Subnet mask : 255.255.255.0
Default gateway : 255.255.255.255 (disabled)
You must set up your computer network properly in order to allow it to communicate with the
TS-9720EN camera. It is very important to that your PC NOT be assigned the same IP address as the
camera. If you need to change the IP address, follow the instructions in Section 2.2.2 on page 4.
EN1* EN2* EN3*
Cat5e/6 Ethernet cable
Ethernet switch
*
Each camera requires a PD-12 12-V power supply.
For details, please see “Power Supplies and Cable Setup.”
1P1 1P2 1P2
PC
EN setup software
Cat5e/6 Ethernet cable
Vista de pagina 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 62 63

Comentarios a estos manuales

Sin comentarios