Pulnix TM-76 Manual de instrucciones descargar pdf (Pagina 12)

Page 6

Installation

TM-75/76 High-Resolution CCD Camera

FIGURE 2. 12P-02S Interface Cable (optional)

Note: Make sure that the unused leads are not touching and that there is no possibility that the

leads could short due to exposed wires.

2.2.2 (c) “K” Series Power Supplies

The “K” series power supplies are designed primarily for OEM users who will be mounting the power

supply inside a protective enclosure. For use in exposed situations, the PD-12UU series power supplies

are recommended. Follow the directions below to connect a “K” series power supply.

1. Attach the 110V line cord to the two terminals marked “AC.” Do not plug the cord into a 110V AC

socket until you have completed steps 2 and 3.

2. Attach the Gray and Yellow leads of the power cable to the Ground and 12V DC terminals, respec-

tively.

3. Replace the plastic terminal guard on the power supply.

2.2.2 (d) Building Your Own Power Cable

Consult the pin-out for the camera purchased. Connect the Ground and +12V power leads of the PD-

12UUP power connector to Pin #1 and Pin #2, respectively (power must be DC regulated, and of

sufﬁcient current to properly power the camera).

2.2.2 (e) Attaching the Power Cable to the Connector

The 12-pin connector is keyed and will only ﬁt in one orientation. Follow these directions to properly

attach the power cable to the camera connector:

1. Rotate the connector while applying slight pressure until the keyways line up.

2. Press the connector into place until ﬁrmly seated.

12P-02S Interface Cable

Pin# Lead Color Function Pin# Lead Color Function

1 Gray GND 7 Black coax VD Input

2 Yellow +12V DC 8 White coax shield GND

3 Red coax shield GND 9 White coax TRIG Input

4 Red coax Video 10 Brown N/C

5 Orange coax shield GND 11 Blue N/C

6 Orange coax HD Input 12 Black coax shield GND

32mm

2,000mm± 10mm

(2 Meters)

PC-12P (Hirose Part #10A-10P-12S/PC12P)

Flying

Leads

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 38 39

Sin comentarios

Pulnix TM-76 Manual de instrucciones Pagina 12