Pulnix TM-76 Manual de instrucciones descargar pdf (Pagina 61)

Page 3

Graphical User Interface

AccuPiXEL Series Camera-Control Software

2 Graphical User Interface

2.1 GUI Features

The following is a list of camera functions that can

be controlled by PC serial commands. The

AccuPiXEL series Camera Link cameras use

differential serial communication through the

Camera Link connector on the rear panel of the

camera.

•

Shutter Mode and Speed

•

Scan Mode (Normal, Binning)

•

Gain

•

LUT (Look-Up Table)

•

Double Knee Control

•

Write / Read settings into / from the EEPROM

2.2 Open the Link to the Camera

For the RS-232 serial port, refer to “Open RS-232

Port”, below. For Camera Link, refer to “Open

Camera Link” below.

2.2.1 Open RS-232 Port

From the main menu tab, select “Comm Port” and

click “Open.” Select the port number, and set 9600

bps, no parity, 8 data bits, 1 stop bit, and click “Done.” Click on the “Report” button and the software

updates the current settings onto the main control panel.

2.2.2 Open Camera Link

Select frame grabber board index. This index is for users who install multiple Camera Link frame

grabbers. For a single board user, the index is selected as zero as default. Once the board index is set,

open Camera Link. Choose the appropriate Camera Link API dll (typically named “clserXXX.dll”)

which is provided by the frame grabber manufacturer. If the board is not installed or the wrong API dll

is selected, an error message appears. If this happens, please contact PULNiX for further assistance.

Click the “Report” button to reﬂect the current settings onto the main control panel.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 71 72

Sin comentarios

Pulnix TM-76 Manual de instrucciones Pagina 61