Pulnix TM-6703 Manual de instrucciones descargar pdf (Pagina 11)

INSTALLATION

Page 6 TM-6703 Progressive Scan Double Speed Shutter Camera

If wiring the PD-12 power supply directly, please note the following

•

Twist the lead ends together and tin solder for strength and electrical continuity

• Use shrink tubing or a similar insulator to prevent exposed leads from touching

• The +12V lead is marked with a red stripe or white lettering; be sure not to reverse the leads

• Properly insulate all connections to prevent shorting

2.2.3 (b) Using PULNiX Power/Video Cables

If you are using PULNiX power cables, such as the 12P-02, KC-10, etc., please refer to the pin-out

diagram. The color coded leads use Grey for Ground and Yellow for +12V DC.

FIGURE 2. 12P-02 Interface Cable (optional)

Note: Make sure that the unused leads are not touching and that there is no possibility that the

leads could short due to exposed wires.

2.2.3 (c) Using the “K” Series Power Supplies

Attach the 110V line cord to the two terminals marked “AC”. Do not plug the cord into a 110V AC

socket until later in the procedure. Next, attach the Grey and Yellow leads of the power cable to the

Ground and 12V DC terminals respectively. Be sure to replace the plastic terminal guard on the power

supply at this time.

12P-02 Interface Cable

Pin# Lead Color Function Pin# Lead Color Function

1 Gray GND 7 Black coax VD Input

2 Yellow +12VCD 8 White coax shield GND

3 Red coax shield GND 9 White coax HD Input

4 Red coax Video 10 Brown N/C

5 Orange coax shield GND 11 Blue Integration

6 Orange coax N/C 12 Black coax shield N/C

32mm

2,000mm± 10mm

(2 Meters)

PC-12P (Hirose Part #10A-10P-12S/PC12P)

Flying

Leads

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 30 31

Sin comentarios

Pulnix TM-6703 Manual de instrucciones Pagina 11