Pulnix TM-6703 Manual de instrucciones descargar pdf (Pagina 12)

INSTALLATION

TM-6703 Progressive Scan Double Speed Shutter Camera Page 7

Note: The “K” series power supplies are designed primarily for OEM users who will be

mounting the power supply inside a protective enclosure. For use in exposed situations,

the DC-12N and PD-12 are recommended.

2.2.3 (d) Building Your Own Power Cables

If you are building your own power cables, consult the pin-out for the camera purchased and connect the

Ground and +12V power leads of the PC-12P power connector to Pin #1 and Pin #2, respectively

(power must be DC regulated, and of sufﬁcient current to properly power the camera).

2.2.3 (e) Attaching the Power Cable to the Connector

The 12-pin connector is keyed and will only ﬁt in one orientation. Rotate the connector while applying

slight pressure until the keyways line up. Press the connector into place until ﬁrmly seated.

The power cord may now be plugged into the 100V AC socket, and the camera powered up.

2.2.4 Attaching the Video Output

Most users utilize the BNC connector for video output from the camera. Connect the output from the

camera to the input of your monitor, VCR or switching device. The input of the monitor should be

balanced for 75Ω termination. Standard RG-59 type coaxial cable should carry a full video signal for up

to 500 feet.

Users wishing to output the video and input the power and sync to a camera over a single cable can use

the PULNiX multi-conductor cables, such as the 12P-02, the KC-10, etc. The mini coaxial leads in

PULNiX multi-conductor cables are designed for short runs of no longer than 100 feet.

Note: Make sure that no extraneous wires are visible which could cause a short.

2.2.5 Attaching the Camera Lens

The TM-6703 camera accepts standard C-mount lenses. To attach the C-mount lens to the camera,

carefully engage the threads and rotate the lens clockwise until it ﬁrmly seats on the mounting ring. Do

not force the lens if it does not seat properly. Please note that some lenses with extremely long

ﬂangebacks may exceed the mounting depth of the camera.

2.2.6 Back Focusing the Lens

To backfocus the TM-6703 camera, ﬁrst attach a C-mount lens in the lens mount. Be sure that the lens is

properly mounted.

Set the lens focus to inﬁnity (if the lens is a manual iris, set the iris to a high f-stop while still retaining a

well-illuminated image). Obtain the best focus possible at this setting, then loosen the two miniature hex

head set screws (hex socket size: 0.89mm) locking the focus ring in place. Now turn the entire lens and

focus ring assembly back and forth until the best image is obtained. Tighten the focus ring set screws.

Your backfocus is now set.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 30 31

Sin comentarios

Pulnix TM-6703 Manual de instrucciones Pagina 12