
________________________________________________________________ ___Appendix C: Cables for cameras
_______________________________________________________________________________________________________
INSPECTA hardware manual Rev 1.77 page 62
6.24 JAI CV-M10BX
(Part # KKRH**M10)
for JAI CV-M10BX (CAMM10BX)
camera mode Nr. of
cameras
Async shutter
0x31F 1 non interlaced, no shutter, one plane
0x32F 1 non interlaced, async. shutter, one plane
0x33F 3 non interlaced, async shutter, three planes
0x4AF 2 non interlaced, async shutter, two planes
For the following modes use B446A high speed analog video interface:
camera mode Nr. of cameras
Async shutter
0x5CC 4 non interlaced, async shutter, four planes
0x5DC 4 non interlaced, async shutter, one plane
Camera back-panel switches:
1: shutter speed ( see camera manual )
2: shutter speed ( see camera manual )
3: shutter speed ( see camera manual )
4: off --> async shutter enable, SW3 on internal PK7945 „on“
on --> async shutter disable, mode 0x31f
5: on, progressive scan, off dual channel
6: gamma correction
7: AGC
8: Manual gain
6.25 JAI CV-M10BX Rev. F
(Part # KKRH**M10F)
for JAI CV-M10BX Rev. F
camera mode Nr. of cameras
0xDFF
1 progressive
0xE0F 1 progressive, async. fixed or variable
shutter
Jumper 12/13 on PK8206 board (or PK8190 for RS version)inside camera must be
changed for fixed or variable shutter:
JP 12 JP 13
Open
open Fixed shutter
Close close Variable shutter
Use driver software ≥ 3.01
Camera back-panel switches:
1: shutter speed ( see camera manual )
2: shutter speed ( see camera manual )
3: shutter speed ( see camera manual )
4: off --> async shutter enable
on --> async shutter disable, mode 0x31f
5: on, progressive scan, off dual channel
6: gamma correction
7: AGC
8: Manual gain
Comentarios a estos manuales