Pulnix TM-76 Manual de usuario descargar pdf (Pagina 72)

________________________________________________________________ ___Appendix C: Cables for cameras

_______________________________________________________________________________________________________

INSPECTA hardware manual Rev 1.77 page 72

6.48 Pulnix TM-1010/ TM-1020/ TM-1040/ TM-1300 10-Bit

(Part # KKRD10XX10B62**)

for PULNIX TM-1010 (CAM1010), TM-1040 (CAM1040), TM-1300 (CAM1300)

31 pin Airborn plug, view on solder pins:

Use Digital Camera Powercable with 12-pin Hirose connector

(Part # KKRPDIGxx)

Camera modes:

camera-mode camera bpp clock Mhz INSPECTA-2 remark

0x27F TM-1010 10 20Mhz MFGI31MZ

0x27C TM-1010 10 10Mhz MFGI31MZ

0x27C TM-1010 10 5Mhz MFGI31MZ

0x39F TM-1010 10->8 20Mhz MFGI31MZ

0x39C TM-1010 10->8 10Mhz MFGI31MZ

0x39C TM-1010 10->8 5Mhz MFGI31MZ

0xAC TM-1010 8 20Mhz MFGI31S (1), (2)

0xAC TM-1010 8 10Mhz MFGI31S (1), (2)

0xAC TM-1010 8 5Mhz MFGI31S (1), (2)

0x27F TM-1040 10 40Mhz MFGI31MZ

0x39F TM-1040 10->8 40Mhz MFGI31MZ

0xAF TM-1040 8 40Mhz MFGI31S (1), (2)

0x6BC TM-1300 10 20Mhz MFGI31MZ (3)

0x6CC TM-1300 10->8 20Mhz MFGI31MZ (3)

0x6DC TM-1300 8 20Mhz MFGI31MZ (3)

remark (1) With the 8-bit INSPECTA-2S (MFGI31S), this cable can be used

together with 10-bit camera (TM-1010/1040), if the camera gain is

reduced to avoid data bits 8&9 going active.

remark (2) For less noise use the „Pulnix TM-1010/ TM-1040 10->8 Bit“ cable

below. Do not use the „Pulnix TM-9701/ TM-1001“ cable.

remark (3) TM-1300: For async shutter Inspecta-2 must have IMP Number >= IMP

383, camera setting: Mode2/down, Mode5/down, select shutter speed

with red shutter wheel

TM-1010/1040 async. shutter camera setting: Mode2/down

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 137 138

Sin comentarios

Pulnix TM-76 Manual de usuario Pagina 72