Pulnix TS-9720EN Series Manual de instalación descargar pdf (Pagina 28)

Page 16

VIS CAM 300/400 Installation Manual

Installing the Vehicle Imaging System

FIGURE 11. TLS-300 signal and power cable.

3. Route the Traffic Light Sensor end of the TLS-300 signal and power cable through the mounting

pipe and the flange (see Figure 12)

4. Screw the flange onto the pipe, finger-tight, to allow

subsequent minor adjustment

5. Attach the cable connector to the Traffic Light Sensor

6. Attach the Traffic Light Sensor body to the flange and

secure it with the four Allen screws

7. Orient the Traffic Light Sensor such that the white

reflectors are parallel to the trigger plane with side B

facing (visible from) the trigger plane

8. Route the free end of the cable to the VIS J-Panel in

accordance with the local code requirements

9. Connect the color-coded wires to J-Panel connector X3

as described in “X3, X7 Traffic Light Sensor ” on

page 22. Make sure that no power is applied when per-

forming any wiring operation.

FIGURE 12.Installing the TLS-300 through the mounting pipe and flange.

TABLE 1. Light Sensor Cables

PIN# Wire color Signal

1 White/green Heater gnd

2 Green Heater gnd

3 Red/blue Heater +24V dc

4 Blue/red Heater +24V dc

5- nc

6Yellow +24V dc

7- nc

8- nc

9- nc

10 White Gnd

11 - nc

12 - nc

13 Brown D1-

14 White/brown D1+

15 Orange D0-

16 White/orange D0+

- Black Shlds

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 115 116

Sin comentarios

Pulnix TS-9720EN Series Manual de instalación Pagina 28