Pulnix TS-9720EN Series Manual de instalación descargar pdf (Pagina 29)

Page 17

VIS CAM 300/400 Installation Manual

Installing the Vehicle Imaging System

3.1.2 Optional Side Mount

1. Attach the pipe clamps approximately 6-inches apart on a vertical

mounting surface as shown in Figure 13.

2. Loosen the four Allen screws and remove the flange from the

mounting base. Figure 10, “Install the traffic light sensor.,” on

page 15.

3. Route the Traffic Light Sensor end of the TLS-300 signal and the

power cable through the pipe and flange.

4. Screw the flange onto the pipe somewhat tightly to allow subse-

quent minor adjustment

5. Place the pipe in the pipe clamps and tighten them to secure the

pipe to the vertical mounting surface.

6. Attach the Traffic Light Sensor body to the flange and secure it

with the four Allen screws.

7. Orient the Traffic Light Sensor such that the white reflectors are

parallel to the trigger plane with side B facing (visible from) the

trigger plane

8. Route the free end of the cable to the VIS J-Panel in accordance

with local code requirements

9. Connect the color-coded wires to the J-Panel connector X3 as

described in Section 3.3 on page 21. Make sure that no power is

applied when performing any wiring operation.

FIGURE 13. Pipe clamps should be about

6-inches apart on a vertical surface.

3.2 Installing the Camera(s)

In general, the camera(s) should be aimed at the most likely cross-lane position of the vehicle license

plates. See “Installation Preparation” on page 6 for general site layout guidelines. To install the

camera(s):

1. Attach the camera mount to the camera enclosure using the included mounting bolts and washers.

Refer to Figure 14.

FIGURE 14. Camera Installation

Approximate weight 6.6 kg

Measurements include the extended sun shield

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 115 116

Sin comentarios

Pulnix TS-9720EN Series Manual de instalación Pagina 29