
Page 51
VIS CAM 300/400 Installation Manual
Appendix A: Camera Functional and Connector Description
Electrical Interface on the I/O board:
FIGURE 45. I/O board electrical interface.
Test
A push button switch S1 can be activated for generation of an output pulse for test purposes. The flash
output is high as long as the switch is activated. The switch is located as shown on Figure 46:
FIGURE 46. Switch location.
5.3.4 Connector physical Interface
TABLE 12. Wiring diagram.
Pin Signal Description Connection to
1 I/O Gnd IO Board Gnd Pin 2 when no power is available from the flash
2 Gnd Flash Gnd Flash ground (negative power terminal)
3 Out Strobe out Strobe input on flash unit
4 Stat Strobe status Status output from flash unit
5 FPWR Flash power Power from flash to output circuit on I/O Board
6 24V IO board 24V (Fused 0.5A) Pin 5 when no power is available from the flash
Comentarios a estos manuales