
Page 69
VIS CAM 300/400 Installation Manual
Appendix B: J-Panel Functional and Connector Description
6.2.3 (b) Trigger output
Description
The trigger output is balanced and the driver is a RS485 transmitter (LTC1480).
Signal levels
The signal levels are at standard RS485 levels. The specification below is taken from Linear
Technologies datasheet for LTC1480:
TABLE 16. Signal parameters and conditions.
Electrical interface on the J-Panel:
FIGURE 65. J-Panel electrical interface
6.2.3 (c) Ethernet Interface
100 Mb Ethernet interface. The signals are routed directly to RJ45 connector X11. The cable to the
camera must be a Cat 5e or preferably a Cat 6 cable. The wire color marking on the PCB uses standard
Ethernet wire colors.
6.2.3 (d) Power output
Voltage 24VDC from power supply connected to X6 or X7
Current 2A fused
Comentarios a estos manuales