Pulnix TS-9720EN Series Manual de instalación descargar pdf (Pagina 54)

Page 42

VIS CAM 300/400 Installation Manual

System Set-Up

4.1.11 Flash Head Alignment

The following section provides a general procedure to align the VIS flash head. Be sure to follow any

specific alignment procedure provided with your system.

Align the flash head at night and after aligning the cameras. Park a light colored vehicle underneath the

camera and where the vehicle detector triggers the camera.

• Press the “Repetitive Trigger” button on the ENSetup toolbar. This will trigger the camera every

second. Make sure that the “Ethernet” external hardware trigger is enabled in the “Camera Proper-

ties” section “2 – Trigger”, property “External Trigger Source”.

• Adjust the flash head tilt and pan control until the entire back of the vehicle is well illuminated. If

necessary, adjust the flash-head pan control to center the flash beam over the vehicle.

• If the flash illumination is too bright for your installation, contact JAI for instructions on how to

adapt VIS system parameters to reduce sensitivity to nighttime illumination.

Repeat pressing the “Repetitive Trigger” button on the ENSetup toolbar to stop flash firing. Repeat the

above steps for each camera/flash.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 115 116

Sin comentarios

Pulnix TS-9720EN Series Manual de instalación Pagina 54