Pulnix TS-9720EN Series Manual de instrucciones descargar pdf (Pagina 34)

Page 24

Installation and Operation

VIS 300/400 EN Setup Software

FIGURE 32. Video Window Tree View Menus

2.6.5 (b) =>Search for cameras

This command starts a new search for cameras on the local network.

The O

PENING NEW CAMERAS message box (see Figure 15 on page 12) is shown while searching for

cameras

If any IP-address problems are detected then a window will be displayed and it will be possible to

correct these problems (see appendix B for a description on how to correct IP-address problems).

2.6.5 (c) =>Open Camera

This command opens a specific camera by specifying an IP-address. This can be used, if the camera is

not on a local subnet and therefore not found automatically during a search (search: see Section 2.3 on

page 4 or Section 2.4 on page 4). This will open an Open Camera dialog where the IP-address can be

typed in (see Section 2.3 on page 4).

2.6.5 (d) =>Manual Exposure

This command opens a new window where the Camera Exposure (Shutter, Gain, Pedestal, VTop/

VBottom and Gamma) can be controlled manually. See Section 2.6.12 on page 42 for a full description

of the Manual Exposure Window. This is typically used when adjusting the cameras in low light

conditions during installation/adjustment at the roadside in the night.

2.6.5 (e) =>Laser Setup

This command opens a new window where a serially connected Laser Trigger can be Setup. See

Section 2.6.14 on page 43 for a full description of the Laser Setup Window. This is typically used when

adjusting and testing the internal trigger setting of the Laser Trigger.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 71 72

Sin comentarios

Pulnix TS-9720EN Series Manual de instrucciones Pagina 34