
Kamerakabel
_______________________________________________________________________________________________________
INSPECTA hardware manual Rev 1.86 page 72
0x27C TM-1010 10 5Mhz MFGI31MZ
0x39F TM-1010 10->8 20Mhz MFGI31MZ
0x39C TM-1010 10->8 10Mhz MFGI31MZ
0x39C TM-1010 10->8 5Mhz MFGI31MZ
0xAC TM-1010 8 20Mhz MFGI31S (1), (2)
0xAC TM-1010 8 10Mhz MFGI31S (1), (2)
0xAC TM-1010 8 5Mhz MFGI31S (1), (2)
0x27F TM-1040 10 40Mhz MFGI31MZ
0x39F TM-1040 10->8 40Mhz MFGI31MZ
0xAF TM-1040 8 40Mhz MFGI31S (1), (2)
0x6BC TM-1300 10 20Mhz MFGI31MZ (3)
0x6CC TM-1300 10->8 20Mhz MFGI31MZ (3)
0x6DC TM-1300 8 20Mhz MFGI31MZ (3)
remark (1) With the 8-bit INSPECTA-2S (MFGI31S), this cable can be used
together with 10-bit camera (TM-1010/1040), if the camera gain is
reduced to avoid data bits 8&9 going active.
remark (2) For less noise use the „Pulnix TM-1010/ TM-1040 10->8 Bit“ cable
below. Do not use the „Pulnix TM-9701/ TM-1001“ cable.
remark (3) TM-1300: For async shutter Inspecta-2 must have IMP Number >= IMP
383, camera setting: Mode2/down, Mode5/down, select shutter speed
with red shutter wheel
TM-1010/1040 async. shutter camera setting: Mode2/down
6.56 Pulnix TM-1300 analog
(Part # KKRH**1300)
for PULNIX TM-1300 (CAM1300)
TM-1300 is connected to the Inspecta via one cable. There are two connectors on
the camera side, the Hirose 12-P and the 15P three row D-connector.
Remark 1: modification inside TM-1300 camera. Connect this pin with pin 1 of
31-pin Airborn connector (signal: CLK+)
camera mode control switch: pos 5/down for 12fps analog output
pos 2/up for manual shutter
pos 2/down for async shutter
camera mode
0x8DC
6.57 Pulnix TM-1300 analog with RS-232
(Part # KKRH**1300R)
for PULNIX TM-1300 (CAM1300)
TM-1300 is connected to the Inspecta via one cable. The cable is split on the
Inspecta side (15-pin D-Sub) for the additional COMx connector. (ca 30cm
, 9-pin
D-Sub)
There are two connectors on the camera side, the Hirose 12-P and the 15P three
row D-connector.
Comentarios a estos manuales